INSTALLATION
REQUIREMENTS
Gather the required tools and parts before starting installation.
Read and follow the instructions
provided with any tools listed
here.
Tools Needed
•
Pliers
•
Phillips screwdriver
•
Flat-blade screwdriver
•
3/16" a nd 1¼,, n ut drivers or
hex sockets
•
Measuring tape or ruler
•
1W' hole saw bit
•
10" adjustable wrench
•
Utility knife
•
Level
•
Cordless drill
•
V8"drill bit
•
Security T-20 TORX_t
driver (on some models)
Pa_s Needed
A. 72" (182.9 cm) flexible water supply line
B. Zip tie
C. Appropriate sized UL Listed wire connectors (2)
1-®TORX is a registered
trademark of Acument
Intellectual
Properties,
LLC
Parts Supplied
Check that all parts are included.
A. _" UL Listed/CSA
Approved
strain relief
B. 1.25" hose clamp
C. Mounting bracket screws (8)
D. Unit mounting screws (4)
E. Drain hose connector
F. Mounting brackets (4)
G. Drain connector spring
clamps (2)
_G
N
H. Trim strips (2)
I. Toe kick brackets (2)
J. Toe kick bracket screws (2)
K. Toe kick trim
L. Panel fasteners (on some
models) (2)
M. TORX®_screws (on some
models) (10)
N. Drain hose