Installation Requirements; Tools And Parts; Location Requirements - Maytag DK724Q1ASS0 Installation Instructions Manual

INSTALLATION REQUIREMENTS
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Parts Supplied
Check that all parts are included.
Tools needed
• Pliers
• Phillips screwdriver
• Flat-blade screwdriver
• 3/le"and 1¼,, n ut drivers or
hex sockets
• Measuring tape or ruler
• 10" adjustable wrench
• Utility knife
• Level
• Electric drill
• 1/8"drill bit
A ............... _ B _
• 1V2" hole saw bit
Parts needed
C D
,j_, ........
G
A. 72" (182.9 cm) flexible water supply line
B. Zip tie
C. 2 appropriate sized UL fisted wire connectors
K
A. _" UL fisted strain refief
B. 1.25" hose clamp
C. 8 mounting bracket screws
D. 4 unit mounting screws
E. Y drain connector
F. 4 mounting brackets
G. Drain connector spring
clamps
H. 2 trim strips
I. Toe kick brackets
J. 2 toe kick bracket screws
K. Toe kick trim
L. 2 panel fasteners (on some
models)
M. 10 TORX_ screws (on some
models)
IMPORTANT: Observe all governing codes and ordinances.
Failure to meet codes and ordinances could lead to fire or
electrical shock.
Proper installation is your responsibility.
• Contact a qualified installer to ensure that the dishwasher is
installed to meet all electrical and plumbing national and local
codes and ordinances.
• Install the dishwasher as specified in these instructions.
• Have everything you need to properly install dishwasher.
• Keep the dishwasher and water lines leading to dishwasher
from freezing. Damage from freezing is not covered by the
warranty.
• This dishwasher is manufactured for indoor use only.
• Install and level dishwasher on a floor that will hold the
weight, and in an area suitable for its size and use.