Move Dishwasher Into Cabinet Opening - Maytag MDB7759AWB3 Installation Instructions Manual

Check t hatwaterlineisontheleftsideofopening and
drainhose is near t hecenter o fthecabinet opening.
Withanother p erson holding thedishwasher to prohibit
it fromtipping, o pen andclose thedoora fewtimes. I f
thedoorcloses orfallsopenunder i tsownweight, t he
doortension will need to beadjusted.
screw _ []
To adjust the door spring tension, unhook the spring
from the rear leg of dishwasher.
Using a sAe"nut driver or hex socket, remove the screw
from the tensioner.
The screw can be put into one of three holes II!,1_,1_
in the front leg of dishwasher. If the door closes by itself,
move the tensioner to a higher number hole and replace
screw. Reattach door spring to rear leg.
NOTE: Tensioners on both sides of dishwasher should be
secured at same holes.
16
When door is unlatched, and door opens by itself, move
the tensioner to a lower numbered hole and replace the
screw. Reattach door spring to rear leg.
NOTE: Tensioners on both sides of dishwasher should
be secured at same hole.
Move dishwasher int
cabinet opening |
blanket
IMPORTANT: If wheels were removed, avoid damage to
the floor when moving the dishwasher. Slowly move
dishwasher completely into cabinet opening. Do not kink
or pinch water line, drain hose, power supply cord or
direct wire between dishwasher and cabinet. Remove
cardboard from under dishwasher.
NOTE: It is all right if dishwasher fits tightly into cabinet
opening. Do not remove insulation blanket- the blanket
reduces the sound level.
NOTE: If using power cord, make sure to route end
through hole in cutout before sliding into cabinet opening.
Align front of dishwasher
Align front of dishwasher door panel with front of
cabinet doors. You may need to adjust alignment to be
even with your cabinets.