Table of Contents
Advertisement
Available languages
Available languages
WARNING
ART# 9_15-Z5_
THISPRODUCTSHOULDNOT BE INSTALLED
BELOWA VENTILATION TYPE HOODSYSTEM
THATDIRECTS AIR IN A DOWNWARD DIRECTION.
(SEEFIGURE)
THESESYSTEMS MAYCAUSEIGNITION AND
COMBUSTION PROBLEMS WITHTHE GAS
BURNERS RESULTING IN PERSONAL INJURYAND
MAYAFFECTTHE COOKINGPERFORMANCE OF
THE UNIT.
NOTE:THE FIGUREMAYNOTACCURATELY
REPRESENT YOURRANGEOR COOKTOP;
HOWEVER, T HISWARNINGAPPLIESTOALL GAS
COOKING PRODUCTS.
ANTI-TIP
DEVICE INSTALLATION
INSTRUCTIONS
NOTE: A risk of range tip over exists if the appliance is
not installed in accordance with the installation
instructions provided. The proper use of this device
minimizes the risk of TIP-OVER. In using this device the
consumer must still observe the safety precautions as
stated in the USE and CARE MANUAL and avoid using
the oven door and/or lower drawer as a step stool.
Installation instructions are provided for wood and cement
in either floor or wall. Any other type of construction may
require special installation techniques as deemed
necessary to provide adequate fastening of the ANTI-TIP
bracket to the floor or wall.
STEP 1 - Locating The Bracket (see figure 2)
A. Determine where either the right or left "EDGE" of the
range will be located and mark the floor or wall.
B. Place the BRACKET 3-15/16" from the marked
"EDGE" toward center of opening and against the back
wall as shown in figure 2,with orientation hole against
wall.
C. Use the bracket as a template and mark the required
holes, as shown in figure 2, for the type of construction
you will be using.
STEP 2 - Anti-Tip Bracket Installation
A. Wood Construction:
,
Floor: Locate the center of the two holes identified
in figure 2 as "HOLES FOR FLOOR". Drill a 1/8"
pilot hole in the center of each hole (a nail or awl
may be used if a drill is not available). Secure the
ANTI-TIP bracket to the floor with the two screws
provided. Proceed to STEP 3.
,
Wall: Locate the center of the two holes identified in
figure 2 as "HOLES FOR WALL". Drill an angled
1/8" pilot hole in the center of each hole as shown
in figure 3. (A nail or awl may be used if a drill is not
available). Secure the ANTI-TIP bracket to the wall
with the two screws provided as shown in figure 3.
Proceed to STEP 3.
ENTATION
HOLE
FOR
WALL
ATTACH
ANTI-TIP
BRACKET
WITH
LONG
SCREWS
-TIP
BRACKET
[10
CM]
FROM
EDGE
OF
RANGE
EDGE
OF
RANGE
___-LEVELINGFooT
HOLES FOR
FLOOR
FIGURE 2
-4-
Advertisement
Table of Contents
