Completing The Parts Replacement - Lenovo ThinkCentre Hardware Maintenance Manual

Figure 28. Removing the internal speaker
6. Position the new internal speaker into the metal clips
secured by the lock latch
7. Connect the new internal speaker cable to the system board. See "Locating parts on the system board"
on page 67.
8. Go to "Completing the parts replacement" on page 87.

Completing the parts replacement

After completing the installation or replacement for all parts, you need to close the computer cover and
reconnect cables. Depending on the parts you installed or replaced, you might need to confirm the updated
information in the Setup Utility program. Refer to Chapter 6 "Using the Setup Utility" on page 39.
To close the computer cover and reconnect cables to your computer, do the following:
1. Make sure that all components have been reassembled correctly and that no tools or loose screws
are left inside your computer. See "Locating components" on page 66 for the locations of various
components in your computer.
2. If you have removed the front bezel, reinstall it. See "Removing and reinstalling the front bezel" on
page 69.
3. Make sure that the cables are routed correctly. Keep cables clear of the hinges and sides of the computer
chassis to avoid interference with closing the computer cover.
1
.
2
and push the internal speaker upwards until it is
Chapter 8
87
.
Replacing FRUs