Lenovo ThinkCentre Hardware Maintenance Manual page 55

Machine types: 3025, 3034, 3131, 3142, 3244, 3257, 3307, 3356, 3467, 3357, 3692, 3853, 4394, 5092, 5226, 5296, 6667, and 6673
Hide thumbs Also See for ThinkCentre:
Table of Contents

Advertisement

Diagnostic Error Code
006-196-XXX Diskette interface test halt, error threshold
exceeded
006-197-XXX Diskette interface test warning
006-198-XXX Diskette interface test aborted
006-199-XXX Diskette interface test failed, cause
unknown
006-25X-XXX Diskette interface Error
015-000-XXX USB port Interface Test Passed
015-001-XXX USB port Presence
015-002-XXX USB port Timeout
015-015-XXX USB port External Loopback failure
015-027-XXX USB port Configuration/Setup error
015-032-XXX USB port Device Controller failure
015-034-XXX USB port buffer allocation failure
015-035-XXX USB port Reset condition detected
015-036-XXX USB port Register error
015-040-XXX USB port IRQ failure
015-195-XXX USB port Test aborted by user
FRU/Action
1. Press F3 to review the log file.
2. Restart the test to reset the log file.
1. If a component is called out, make sure it is connected
and/or enabled .
2. Re-run the test.
3. Replace the component that is called out in warning
statement.
4. Replace the component under test.
1. If a component is called out, make sure it is connected
and/or enabled.
2. Flash the system and re-test. See "Updating (flashing)
BIOS from a disc" on page 324.
3. Go to "Undetermined problems" on page 62.
1. Go to "Undetermined problems" on page 62.
2. Flash the system and re-test.
3. Replace component under function test.
1. Diskette drive cable
2. Diskette drive
3. System board
No action
1. Remove USB device(s) and re-test
2. System board
1. Remove USB device(s) and re-test
2. System board
1. Remove USB device(s) and re-test
2. System board
1. Flash the system. See "Updating (flashing) BIOS from
a disc" on page 324
2. System board
System board
1. Reboot the system
2. Flash the system and re-test. See "Updating (flashing)
BIOS from a disc" on page 324.
3. Run memory test
4. System board
1. Remove USB device(s) and re-test.
2. System board
System board
1. Run the Setup Utility program and check for conflicts.
2. Flash the system. See "Updating (flashing) BIOS from
a disc" on page 324.
3. System board
Information only Restart the test, if necessary.
Chapter 7
.
Symptom-to-FRU index
49

Advertisement

Table of Contents
loading

Table of Contents