Table of Contents
Advertisement
Hoover_Stabiliser_FINAL_Vs2c_01_03_06.qxp
PREPARING TO USE YOUR CLEANER
1
Insert handle into body of cleaner. Slide into
position.
Ensure handle is flush with body of cleaner.
Tighten large screw (pre-fitted to handle
upper hole). Insert small screw into handle
lower hole and tighten.
2
Locate hose end, turn clockwise to lock.
3
Locate hose retainer on lower hose support.
4
Position hose over hose supports.
5
Push handgrip firmly into socket.
Clip tools to back of cleaner.
Check that dust container is fitted
POWER SWITCH SETTING
Switching on and o
Push bottom of the switch to switch on.
Push top of switch to switch off.
01/03/2006
10:28
Page 4
2
1
CARPET HEIGHT SELECTOR
The carpet height selector raises or lowers the height of
the nozzle.The nozzle height will not change until the
handle is released.Try various settings until you get the
best results for each of your carpets.
3
4
Ensure that the cleaner
is in an upright (parked)
position.
Slide selector to position
best suited to depth of
carpet pile.
Using this cleaner for carpets with pile greater than
5
30mm is not recommended.
HANDLE LOCK RELEASE
-4-
!
IMPORTANT:When cleaning hard oors
such as vinyl or linoleum, move the
"Carpet Height selector" to the
Hard oor position. Failure to do so may
cause damage to the oor surface.
Unlock the handle by pressing
down on pedal with foot. For
cleaning under low
furniture and some
maintenance tasks
simply press
pedal again and
lower handle
to floor.
Advertisement
Table of Contents
