Table of Contents
Advertisement
Hoover_Stabiliser_FINAL_Vs2c_01_03_06.qxp
EMPTYING AND CLEANING THE DUST
CASSETTE AND FILTERS*
Press down on door release pad and remove door. Pull out the dust cassette. Empty
the cassette of dirt and debris. Clean the Red cyclonic screen after each empty.
Washing cassette lter and foam:
Washing pre-motor and exhaust lter:
The pre-motor lter
months.Wash under hand warm water. Remove excess water
by shaking and leave to dry for 24 hours.When completely
dry, refit the filter.
Carbon lter
Normally maintenance free, this component should not be washed. If a replacement is
required please contact our spares department.
The exhaust lter
press down on the latch to remove the exhaust cover
and filter.
Wash under hand warm water.
Remove excess water by shaking and leave to dry for
24 hours.
* Features vary according to model
01/03/2006
10:28
Page 8
After emptying the cassette 5
times, wash the Blue top filter and
and foam under hand warm water.
Remove excess water by shaking
and leave to dry for 24 hours.
Do not use a brush as this will
damage the filter.
should be washed every three
should be washed every 3 months.
User checklist
If your cleaner is not working properly run through the following checklist.
1.
Is there a working electricity supply to the cleaner?
check with another electrical product.
2.
Is the dust container full or choked with ne dust?
To empty the dust container see the instructions on page 8.
3.
Is the hose blocked?
To clear a blockage, see the instructions on page 6.
4.
Is there a blockage in the cleaner base?
To clear a blockage, see the instructions on page 6.
5.
Are the lters blocked?
To clear the lters, see the instructions on page 8.
6.
Is the nozzle height set correctly?
To set the carpet height selector, see the instructions on page 4.
7.
Are the brushes rotating correctly?
To check the brushes, see the instructions on page 6.
8.
Has the cleaner overheated? If so, it will take about 30 minutes to reset itself.
If there is any doubt call the Hoover Service O ce for advice. They may be
able to assist you over the telephone.
A service charge will be made if the cleaner is examined and found to be in
working order, has not been assembled in accordance with these instructions or
has been used incorrectly.
WARNING!
A thermal cut out switches o the cleaner to prevent
overheating if it is used when full or there is a blockage or
dirty lters. If this should happen switch o , unplug and
correct the fault.
It will take about 30 minutes for the cut out to
automatically reset.
IMPORTANT:
Do not run cleaner over the supply
cord as this could damage the supply cord insulation.
-8-
®
*
Hoover Limited
Pentrebach
Merthyr Tyd l
Mid Glamorgan
CF48 4TU
© 2006
®
Registered Trade Mark
Part Number: 0565 5261
Advertisement
Table of Contents
