Assigning Inputs To Input Sources - Onkyo TX-L55 Instruction Manual

Basic Setup —Continued
3
Use the [CH SEL] button to select
the speakers, and use the
CH SEL
[LEVEL+] and [LEVEL–] buttons
to adjust the volume.
The level can be adjusted from –12 to
+12 dB in 1 dB steps.
LEVEL LEVEL
+
-
If you don't press anything for two sec-
onds, the next speaker will be selected
automatically.
4
Repeat step 3 until the volume of
the test tone coming from each
speaker is the same.
Speakers that you set to No or Non in
the Speaker Configuration (page 48) do
not output the test tone.
5
Press the [TEST TONE] button.
The setup menu closes.
TEST TONE
Don't forget to turn down the volume if
you turned it up while setting the levels.
Notes:
• This procedure can also be performed by using the
[SETUP] button. Press the REMOTE MODE [AMP]
button followed by the [SETUP] button. Use the Up
and Down [ ]/[ ] buttons to select "Level Cal," and
then press [ENTER]. Use the Left and Right [
buttons to adjust the speaker volume, and use the
Down [ ] button to select the next speaker. Unlike the
above procedure, the next speaker will not be selected
automatically after two seconds.

Assigning Inputs to Input Sources

Digital Audio Input Setup
To enjoy Dolby Digital and DTS, you must connect your
DVD player to the TX-L55 by using a digital audio con-
nection (coaxial or optical).
This section explains how to change the digital audio
input socket to input source assignments. You only need
to change them if your connections don't match the
defaults listed in the following table.
Input source Default digital input assignment
DVD COAX
TV OPT1
VIDEO1 OPT2
VIDEO2 - - - - (Analog)
AUX - - - - (Analog)
For example, if you connect your DVD player to the
OPT 1 DIGITAL INPUT, you'll need to change the
DVD input source from COAX to OPT 1.
If you want to use the TV input source with only the
analog TV IN, change the TV input source assignment
from OPT1 to "----" (Analog).
You can change the assignments as follows.
1 Press the REMOTE MODE [AMP]
button followed by the [INPUT
AMP
TUNER
SELECTOR] button for the input
source whose assignment you
want to change.
There is no assignment for the TUNER
DVD V1 V2
input source.
INPUT SELECTOR
TV AUX TUN
2 Press the [SETUP] button.
3
Use the Up and Down [
buttons to select "Input Set," and
ENTER
then press [ENTER].
ENTER
]/[ ]
4
Use the Up and Down [
buttons to select "Digital In," and
then use the Left and Right [
[
ENTER
COAX: Select if the component is
OPT1: Select if the component is
OPT2: Select if the component is
5
Press the [SETUP] button.
The setup menu closes.
]/[
]/[
] buttons to select:
connected to the COAX DIG-
ITAL INPUT.
connected to the OPT1 DIGI-
TAL INPUT.
connected to the OPT2 DIGI-
TAL INPUT.
]
]
]/
31