Installation Requirements - KitchenAid KUDD01DSSS0 Installation Instructions Manual

INSTALLATION REQUIREMENTS
Gather the required tools and parts before starting
instalhtion, Read and follow the instructions provided with
any tools listed here,
Tools needed: [] 7 mm socket wrench
[] utility knife [] 5 mm socket wrench
[] needle-nose pliers [] 5 mm open end or box end
[] tape measure wrench
[] flat-bladed screwdriver [] electric or hand drill
[] #2 Phillips screwdriver [] 1-1/2" hole saw
[] side cutting pliers [] valve (sized to fit hot water
supply line) with 3/8" male
[] pencil compression fitting
[] sandpaper [] protective floor covering
[] level
[] wood cutting board
[] adjustable wrench that
opens to 1-1/8" (29 mm)
IMPORTANT: Observe all governing codes and ordinances.
Failure to meet codes and ordinances could lead to fire or
electrical shock.
Proper installation is your responsibility:
[] Contact a qualified installer to ensure that the dishwasher is
installed to meet all electrical and plumbing national and local
codes and ordinances.
[] Install the dishwasher as specified in these instructions.
[] Have everything you need to properly install dishwasher.
[] Protect dishwasher and water lines leading to dishwasher
against freezing. Damage from freezing is not covered by the
warranty.
[] This dishwasher is manufactured for indoor use only.
[] Install and level dishwasher on a floor that will hold the weight,
and in an area suitable for its size and use.
Product dimensions
Parts supplied:
Located in bottom drawer:
[] 2 flexible trim pieces (for sides)
[] 1 flexible trim piece (for top)
[] edge protection
[] hose clamp, hose type
[] washer
[] 2 installation brackets (top)
[] drain hose support
[] drain hose connector
[] 2 hose clamps, wire type
[] 24 #8 Phillips head wood screws
[] toe panel
[] custom toe panel mounting bracket
[] moisture protection tape
22-7/16" * .__ 23-7/18"
(57 cm)
raised tabs for
optional t op
attaching
brackets
\
_ 20-15/32"
(52 cm)
_ drawer open //1_
(59.5 cm)
32-3/16" -
34-1/2"
(81.8 cm -
87.8 cm)
side
attaching --S
tabs
2"- 4-3/8 ....
(5 cm - 11 cm)
* If custom wood panels are to be used, the product depth is specified with an
11/18'* (18 ram) door panel thickness.
** Toe panel depth: Factory supplied, 2-4-3/8" (5 - 11 cm); Custom wood, 5**
(12.7 cm) less the toe panel thickness for integrated. Minimum panel thickness
using the supplied screws is 3/8'* (9 ram).
*** Door front height: Factory supplied - 30" (76.2 cm); Custom wood - 28-1/4'*
(71.8 cm) minimum.
NOTE: Product shown with front panels for dimension purposes.