KitchenAid KUDD01DSSS0 Installation Instructions Manual page 11

5. Attach thedrainhose connector totheairbreak using
thesupplied h ose clamp,
EJ_ air break
E
drain hose
connector
waste
water supply
8" (20.3 cm) min. bend
radius from valve
2,
install the flat seal washer on the end of the inlet hose.
Connect the inlet hose to the water supply valve. Tighten
securely.
Turn the water valve on and check for any leaks.
va,ve0 f,atsea,
3, Open top drawer. Remove the packing tape from the front
and rear of dish rack.
4, Close drawer.
5, Open bottom drawer. Remove the packing tape from the front
and rear of dish rack.
6, Close drawer.
1. Remove front panels from box and discard all shipping
material.
2. On the shorter front panel (lower drawer), remove the
tape securing the connector and wires. Discard tape.
3. Connect the end of the medallion connector to the
connector from the lower drawer.
wire
opening
end of medallion
connector
lower front
panel
4,
5,
Gently feed the wires and connectors into the metal plate
wire opening.
Line up front panel tabs to slots in metal plate, Do not
puii the connector from wire opening,
slots _ "- front panel
._.__.... _'_m ata, plat e \_
6. Push the front panel down to lock in place.
7. Repeat steps 2-6 for the top drawer panel.
8. When installed properly, top panel should be even with
top of dishwasher with a 3/8" (9.5 ram) gap between the
top and bottom panel
11