KitchenAid KUDD01DSSS0 Installation Instructions Manual page 10

Option 2: Top attachment
1, If the top attaching brackets are used, open the top drawer
slightly:
2, Screw the top attaching brackets to the underside of the
counter with two #8 Phillips head screws.
IMPORTANT: The top attaching brackets can accommodate
a maximum 3/4" (19 mm) vertical gap.
....... top attaching bracket
3, Close the top drawer,
Option 1: Sink drain waste tee connection
1, Route the drain hoses as shown and press the hoses into
the drain hose support.
2, Decide if the drain hoses need to be trimmed, If they do,
trim them,
3, Slip a wire clip over each drain 7_ wireclip
hose. Push the hoses into the
drain hose connector firmly,
5 ciicks,
4, Position the wire clips between
the two positioning ribs on the drain hose
drain hose connector, connector
5, Attach the drain hose connector to the waste tee using
the supplied hose clamp,
6, Attach the drain hose support bracket to the cabinet with
a #8 Phillips head screw at the height shown below,
NOTE: The drain hose connector must not support the weight
of excess hose length. Keep hoses as fully extended as
possible.
Option 2: Garbage disposaB connection
1, Route the drain hoses as shown and press the hoses
into the drain hose support,
Decide if the drain hoses need to be trimmed, If they do,
2,
3,
4,
trim them,
Slip a wire clip over each drain
hose, Push the hoses into the
drain hose connector firmly,
5 clicks,
Position the wire clips between
the two positioning ribs on the
drain hose connector,
50 wire clip
wire clip ¢_
drain hose
connector
5,
6,
Attach the drain hose connector to the garbage disposal
using the supplied hose clamp,
Attach the drain hose support bracket to the cabinet with
a #8 Phillips head screw at the height shown below,
NOTE: The drain hose connector must not support the
weight of excess hose length. Keep hoses as fully extended
as possible.
o_
!
oE
water supply
..... 8 " (20,3 cm) rain. bend
radius from valve
Option 3: Air break connection
1, Route the drain hoses as shown,
2,
3,
4,
Decide if the drain hoses need to be trimmed, If they do,
trim them,
Slip a wire clip over each drain
hose, Push the hoses into the
drain hose connector firmly,
5 clicks,
Position the wire clips between
the two positioning ribs on the
drain hose connector,
#_) wire clip
wire clip U
drain hose
connector
10