KitchenAid KUDD01DSSS0 Installation Instructions Manual page 12

Option1:Insta{Istandardtoe pane{
NOTI=S: Depending oncountertop height, youmay nothave to
trimthetoepanel.
Rugs p laced infront o fdishwasher could interfere with
toepanel. Clearance between floorand toepanel may
need toinclude t herugthickness.
1. Partially open thebottom drawer.
2. Turn thetoepanel upside d own andhold vertically against the
bottom edge ofthetubside (not t hefront).
3. Onthetoepanel, mark where t hetub's bottom edge is.
7,
8,
Remove any rough edges by sanding smooth,
Partially open bottom drawer. Position toe panel behind door
and slide onto the underside of tub.
toe panel clamping (_
mounting rail screw
bottom edge
of tub side
Close the drawer. Check that there is
1/2" (12.7 mm) minimum clearance
between the bottom edge of the toe
panel and the floor.
if not, remove the toe panel and shorten
using the utility knife. Remove any rough
edges.
10. Slide toe panel back onto mounting rails.
ss{{_ i (12_7 mm)
floor
11. If needed, you may simply push the toe panel back or forward
on the mounting rail.
12. With a Phillips screwdriver, tighten the toe panel clamping
screws on both sides.
13. Plug in dishwasher or reconnect power.
14. Go to "Complete Installation" section.
4,
5,
6,
On a stable surface, place toe panel on a wooden cutting
board and pick the closest groove to the mark. If the mark is
between two grooves, choose the groove that makes the toe
panel the shortest.
At the selected groove, use a utility
knife and cut the vertical rib the
length of the toe panel until entire
piece is removed.
ear of
Snap off the toe panel tabs. toe panel
toe panel
tabtoe panel
12