KitchenAid KUDE40FXPA0 Installation Instructions Manual page 16

Visible side
Attach the4 plastic studs tothewooden panel u sing the
4 shorthexhead (sA6") screws provided.
Align studs
Wooden panel
assembly
Align the studs on the custom wood panel to the keyhole
slots on the door assembly. Ensure that all 4 plastic studs
are engaged in the keyhole slots. Slide wood panel down
until the top surface of the wooden panel is flush with the
top of the door.
li:_g n top_ C_-\'
edges
Drill through _ )
Customer-supplied
theseholes.
panel
Open the door and align top edges. Predrill two pilot holes
using a 3/32"drill bit. Use tape to mark the drill bit to gauge
hole depth. Drill pilot holes approximately 11/2 '' (12.7 mm)
into the top corners of the door using hole in liner as a
guide.
Install custom panel
edges
:)rill through
these holes
Customer-supplied
panel
Install 2 long screws supplied in top corners to secure
custom wood panel in place.
Remove the short screws
top
edges
Remove 2 short screw_ Customer-supplied
and replace with long panel
screws provided.
Remove the short screws (3rd from top) on either side of
the inner door panel. Pre-Drill 2 pilot holes using a 3/32"drill
bit. Use tape to mark the drill bit to gauge the hole depth.
Drill pilot holes approximately 11/2 '' using the door liner
hole as a guide into the panel. Install the two remaining
long screws.
iiiiiiii;;iiii;;iii_ii_;iii_i_i_ii_iiii ¸iii_;iii ¸ii_;iii_ii_;iii_ii_;iii_ii_;iii_ii_;iii_i_ii_iiii ¸ii ¸i ¸ii ¸iiiiiii ¸ii ¸i_;iii ¸ii ¸i_;iii ¸ii ¸ii ¸i¸iiii_iiiiii ¸iiiiii ¸ii_;iii_ii_;iii_ii_;iii_ii_;iii_ii_;iii_ii_;iii_ii_;iii_ii_;iii_ii_;iii_ii_;iii_ii_;iii_ ¸ii ¸i_;iii ¸ii ¸ii ¸i¸iiiiiiiiiii ¸iiiii ¸iiiii ¸iiiii ¸iii_i_iiii_i_iiii_iiiiiiiii_i ¸iilii ¸_;_;_;_;_;_;_;_;_;_;_;_;_;_;_;_;_;_;_;_;_;_;
Choose Affachment Option
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
Use 2 or more people to move and install dishwasher.
16