Ricoh Container Stacker Unpacking & Setup Instructions page 37

4. Connect the connector of the AF cable of the 4-pin white and 20-pin black
connectors coming from the Container Stacker 2 to connector CN7 (4 pin) in the
Finisher.
5. Pull the cable through the opening in Container Stacker 2 marked "A" (shown
below).
6. On SW1, set the No. 5 and No. 8 switch to On and set the No. 2 switch to Off.
Printer
7. Install the Rear Covers of the Printer, Container Stacker 2 and the Finisher.
1-32 Container Stacker Installation Instructions
AF cable
Container Stacker 2
(W/ Through path)
Disconnection 2
Disconnection 1
(2 pin white)
(4 pin white)
Connection 2
(20 pin black)
Standard Finisher
Opening "A"
Connection 1
(4 pin white)