Install Container Stacker 1 Or 2 - Ricoh Container Stacker Unpacking & Setup Instructions

3. Turn the four leveling bolts until the casters no longer touch the floor.
4. Using a Level, adust the horizontal level of the rear engine.

Install Container Stacker 1 or 2

NOTE
These installation instructions apply to the 70, 92 and 184 ppm
printers.When installing a Container Stacker on a 184 ppm printer, the
word printer always refers to the Rear Engine unless otherwise specified.
1. Remove the two M3x8 screws and Static Electricity eliminator from the Printer.
2. Install the Guide Plate (U) with the Static Electricity eliminator using the two
M3x8 screws.(the front is lettered on the surface).
NOTE
Take care that nothing interferes with the static eliminator.
3. Install the Guide Plate (L) using the two M3x8 screws with washers.
4. Install Joint Bracket (U) and Joint Bracket (L) using the two M4x8 screws.
1-12 Container Stacker Installation Instructions
Level
:
:
Rear Engine
Leveling Bolt
Caster
Floor
Gap
(Max 1mm)