Table of Contents
Advertisement
Getting started
Headset base and handset lifter installation
Option 2: Connect the headset to a corded phone and
computer (cont.)
4.
Plug the small end of the headset base power adapter
to the POWER jack (green dot) on the headset base.
5.
Plug the large end of the headset base power adapter into a
power outlet not controlled by a wall switch.
6.
Plug the small end of the USB cable into the USB port
labeled
7.
Plug the large end of the USB cable into a USB port on your
computer. Wait for your computer to indicate that it has
recognized the headset.
8.
Plug the end of the lifter control cable into the LIFTER jack at
the back of the headset base.
9.
Use the attached fastener to bundle all line cords neatly.
Make sure the CORDED HANDSET
10.
CONNECTED switch on the right side of the
headset base is set to YES.
11.
Adjust the corded handset audio (see
page 21) before you install the
handset lifter on the corded phone.
12.
For instructions of installing the lifter, see
pages 22-25. For information about the
internal and auxiliary ring detectors, refer to pages 26-27.
Download and install the AT&T Softphone Call Manager on
13.
your computer. The software is available for download at
www.smbtelephones.att.com/downloads
For detailed installation and operating information, refer to
the Installation and Operation Guide for AT&T Softphone
Call Manager, available for download at
www.smbtelephones.att.com/downloads
on the right side of the headset base.
18
10
.
.
Hide quick links:
Advertisement
Table of Contents
