KitchenAid KSSC42QMU00 Installation Instructions Manual page 22

6. Remove the protective skin from the screw covers. Snap the 5. Replace the top grille in the cabinet side trims and pull the
screw covers into the handle trim section, panel down slightly to lock it into place.
Top Grille Panel
1. Grasp both ends of the top grille.
2. Push straight up, then pull straight out. Place the top grille
panel-side down on a soft working surface.
B A B
3=
4=
A. Top grille
B. Cabinet side trim
Remove one end cap by loosening the nuts and sliding the
end cap off.
A
A. Bottom rail C. End cap
B. Nuts D. Top rail
Slide the decorative panel into the top grille channel and
reattach the end cap.
A. Backer panel
A. Top grille
B, Cabinet side trim
! _!!i_'_,i_'_ii!iiii iiiil;ii:_ii!!!:iii::_i:ii_!iii_;!j!iii:_;_ii!_i_:_:!_!_!i,: ¸_
NOTE: Classic and Overlay Series door panels must be installed
before leveling.
1. Open the doors and place the level on top of the refrigerator
frame as shown. Check to see whether the refrigerator is level
from left to right.
B ....... _I_ ...................... B
A. Level to check left to right leveling
B. Level to check front to back leveling
Use the leveling bolts to adjust the leveling legs until the
refri( erator is level from left to right.
j
A. Rear leveling bolt
B, Front leveling bolt
3. Place the level(s) on shelf or shelves as shown. Check to see
whether the refrigerator is level from front to back.
4. Use the leveling bolts to adjust the leveling legs until the
refrigerator is level from front to back.
5. Be sure that all 4 leveling legs contact the floor and support
the full weight of the refrigerator.
6. Make final check to ensure the refrigerator is level.
22