KitchenAid KSSC42QMU00 Installation Instructions Manual page 15

Refrigerator
Overlay
Recessed Inset Installation Dimensions
1. Measure the distance from point A (as shown) to back wall.
2. Route the front edge of the support board or attach a %"
(9.5 mm) board to hold the panel in the cabinet side trim.
Side Trim
3/16"
ram)
3 ii
/8 ._
(9.7 mm)
(1.5 mm)
!
118" -i-
(3.2 mm) 2
Inset Installation Dimensions
1. Measure the distance from point A (as shown) to the back
wall. Add 1/32"(0.8 mm) to this measurement to allow the side
panel to fit into the trim.
2. If the panel is more than %" (9.5 mm) thick, route the front
edge to allow the side panel to fit into the trim.
A
INSTALLATION
REQUIREMENTS
IMPORTANT:
• Installer: Leave Installation Instructions with the homeowner.
• Homeowner: Keep Installation Instructions for future
reference. Save these Installation Instructions for the local
electrical inspector's use.
TOOLS NEEDED:
Make sure that you have the tools necessary for proper
installation:
• Hand drill or electric drill • T27 flat-head 6 point
(properly grounded) driver
• Drill bits • 11/32" nut driver
• Two adjustable wrenches • %" and 1/_,, o pen-end
wrenches
• Phillips screwdriver • 3/=,, Allen wrench
• Small level • 3/16"socket wrench
• Appliance dolly • Tape measure
PARTS NEEDED:
• Six #8 x 3" (7.6 cm) wood screws (longer screws may be needed)
One or two 2" x 4" x 32" (5 cm x 10 cm x 81 cm) wood board(s)
Order factory panels, make custom panels or consult a
qualified cabinetmaker or carpenter to make the panels.
Classic Series: Order factory panels, make custom panels, or
consult a qualified cabinetmaker or carpenter to make the
panels. See "Design Specifications" for more information.
Overlay Series: Make custom panels, or consult a qualified
cabinetmaker or carpenter to make the panels. See
"Installation Requirements" and "Design Specifications" for
more information.
and Architect Series are shipped Pro Line
TM,
Complete ®
complete.
If you are connecting the water line directly to copper tubing
and not to a shutoff valve, you need a ferrule, a union, and a
1/4"(6.35 mm) compression fitting.
15