Install Range Hood; Make Electrical Connection - KitchenAid KWCU480WSS0 Installation Instructions Manual

1.
2.
3.
1.
2.
Use a flat-blade screwdriver and tighten the 2 leveling screws
located close to the range hood mounting brackets.
A. Leveling screw
Using 2 or more people, lift the range hood and place the
mounting hood brackets over the mounting screws. Securely
tighten the screws.
Level the range hood. Adjust the 2 leveling screws (see
Step 1) as needed.
%,. I R:I, _¢ iI
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
Disconnect power.
Remove the filters.
NOTE: Use 2 hands to remove the filters, one to pull and turn
the knob, the other to hold the filter so that it doesn't fall.
Pull knob forward (toward the front of the range hood)
while turning the knob counterclockwise to release the
locking lever.
Slide the filter down and away from the front retaining
channel.
3. Remove terminal box cover.
4. Install a UL listed or CSA approved V2" strain relief in the hole
on top of the canopy.
5.
Run 3 wires, black, white, green or bare through strain relief,
into terminal box. Use caulking to seal openings.
................ E
A. Home power supply cable
B. Black wires
C. UL listed wire connectors
D. White wires
E. Green (or bare) ground wire from home power
supply connected to green ground screw
F. Range hood power supply cable
6. Use UL listed wire connectors and connect the 3 black wires
(B) together (2 wires from the range hood and 1 wire from the
home supply cable).
7. Use UL listed wire connectors and connect the 3 white wires
(D) together (2 wires from the range hood and 1 wire from the
home supply cable).
!
Fire Hazard
Electrically ground the blower.
Use copper wire.
Connect ground wire to green ground screw in
terminal box.
Falure to do so can result in death, fire, or
electrical shock.
8. Connect green (or bare) ground wire from home power supply
to the unused green ground screw (E) in the terminal box.
9. Tighten strain relief screws.
10. Install terminal box cover.
11. Check all light bulbs to make sure they are secure in their
sockets.
12. Reconnect power.
8