Minolta EP1083 Operator's Manual page 103

2. Detailed Instructions for Indicator Lights
5 Close the Front Door.
Plug the Power Cord into the
6
Wall Outlet.
Turn ON the Power Switch.
7
This will cause the wait indicator
1139O6012A
to be shown on the control panel.
8
The copier automatically start
the charging cycle for
approximately 5 minutes.
During this cycles, do not open
the Front Door.
During this cycle, six segments
of the ones digit LED on the
Magnification Ratio Indicator
forming a "0" light up and go out
one after another, indicating that
the copier is being charged with
starter.
When the copier has been
completely charged with Starter,
the indication on the
Magnification Ratio Indicator
changes to "100" and the cycle
1139U011AA
stops.
If "E1" or "E2" is indicated on
the Magnification Ratio
Indicator, the tape has not been
removed from the Starter Bottle.
Swing down the Front Door and
remove the tape and perform the
starter charging procedure again.
If "E1" or "E2" is indicated again
1139U012AA
call your Technical
Representative.
91