ZyXEL Communications NBG4615 User Manual page 348

Appendix I Legal Information
If this device does cause harmful interference to radio/television reception, which can be
determined by turning the device off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
1
Increase the separation between the equipment and the receiver.
2
Connect the equipment into an outlet on a circuit different from that to which the receiver is
3
connected.
Consult the dealer or an experienced radio/TV technician for help.
4
• This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
• IEEE 802.11b or 802.11g operation of this product in the U.S.A. is firmware-limited to channels 1
through 11.
• To comply with FCC RF exposure compliance requirements, a separation distance of at least 20
cm must be maintained between the antenna of this device and all persons.
Industry Canada Statement
This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the
following two conditions:
this device may not cause interference and
1
this device must accept any interference, including interference that may cause undesired
2
operation of the device
This device has been designed to operate with an antenna having a maximum gain of 2dBi and
5dBi.
Antenna having a higher gain is strictly prohibited per regulations of Industry Canada. The required
antenna impedance is 50 ohms.
To reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the EIRP is not more than required for successful communication.
IMPORTANT NOTE:
IC Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
348
FCC Radiation Exposure Statement
NBG4615 User's Guide