Yamaha DTXTREME III Owner's Manual page 148

Appendix
Optional DIMM Installation
DIMM Installation
1
Turn the DTXTREME III power off, and dis-
connect the power cord.
2
Turn over the DTXTREME III so you can
have direct access to the underside.
To protect the data dial and sliders from damage, place the
DTXTREME III so the four corners are supported by some-
thing that provides sufficient support, such as magazines or
cushions. Place supports at all four corners, taking care not to
touch the Data dial and Sliders.
Bottom surface of the
DTXTREME III
3
Remove the slot cover.
Remove the screws from the slot cover by using a Phillips
screwdriver.
Slot cover
Underside of the DTXTREME III
IMPORTANT
Keep the removed screws in a safe place. They will
be used when re-attaching the cover to the instru-
ment after installing the DIMMs.
148
DTXTREME III Owner's Manual
4
Insert the two DIMMs into the DIMM sock-
ets.
Location for DIMM installation
Installing the DIMM modules to the sockets
Rear panel
4-1 Press the ejector levers to the outside of the
4-2 Insert the DIMM vertically in the socket.
DIMM slot x 2
Make sure that the DIMM module is aligned
correctly before you install it.
Notch for alignment
Ejector lever
socket.
Press the DIMM in firmly until it "snaps" or
locks in place.
Confirm whether or not both the levers are
firmly locked.