Velocity Limit - Yamaha DTXTREME III Owner's Manual

B NOTE
Determines the MIDI note number of the corresponding step.
Settings off, C#-2 – G8
NOTE
• For details about the relationship between the Drum Voices and MIDI
note numbers, see page 62.
C GATETIME
Determines the gate time (length from the moment you hit the
pad to the moment the corresponding note off is transmitted to
the tone generator block). In effect, this determines how long
the resulting sound lasts.
Range 0.0s – 9.9s
D [SF3] ALL
Regarding the CH, NOTE, GATE TIME and VELOCITY
LIMIT parameters, you can change the current values of all
the steps by simultaneously holding this button and using the
data dial, [INC/DEC] and [DEC/NO] buttons.
E [SF4] STEP
Regarding the CH, NOTE, GATE TIME and VELOCITY
LIMIT parameters, you can change the current values of the
current step number by simultaneously holding this button
and using the data dial, [INC/DEC] and [DEC/NO] buttons.
F > (page)
This appears when another page can be called up from the
current page. Use the Cursor [
another page.
The second page:

1 VELOCITY LIMIT

Determines the minimum and maximum values of the veloc-
ity range within which the Drum Voice will sound. The Drum
Voice will sound only when you hit the pad at velocities
within the range specified here.
Range 0 – 127
M N
] or [ ] button to call up
1
■
Example Stack/Alternate program
Here is an example of how you can use Stack/Alternate.
In this example, hitting the pad once produces a C major
chord. Hitting it a second time produces a G major chord,
and a third hit produces a C major chord again.
Example program of the Stack/Alternate
Step 001
The program for hitting the pad for the first time.
Step 002
The program for hitting the pad for the second time.
Step 003
The program for hitting the pad for the third time.
To create the above program, follow the procedure below.
1
Press the [F6] OTHER button followed by
the [SF3] MIDI button to call up the MIDI
display, allowing you to set the tone gener-
ator settings for each of the MIDI 16 chan-
nels.
2
Move the cursor to channel 11.
3
Move the cursor down to the TRANSMIT
row, then set the TRANSMIT parameter of
channel 11 to "All" or "PC."
Reference
Drum Kit Mode [DRUM KIT]
DTXTREME III Owner's Manual
87