Replacing The Cover Presence Switch - Lenovo ThinkStation E32 User Manual

7. Pull on the tips of the rubber mounts until the rear fan assembly is secured in place.
Figure 58. Installing the rear fan assembly
8. Connect the rear fan assembly cable to the system fan connector on the system board.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 79.

Replacing the cover presence switch

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
on page v.
This section provides instructions on how to replace the cover presence switch (intrusion switch).
To replace the cover presence switch, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See "Removing the computer cover" on page 32.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 33.
4. Locate the cover presence switch. See "Locating components" on page 11.
66
ThinkStation E32 User Guide