Installing The Tertiary Hard Disk Drive - Lenovo ThinkStation E32 User Manual

• To complete the installation or replacement, go to "Completing the parts replacement" on page 79.

Installing the tertiary hard disk drive

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
on page v.
Note: You can install a tertiary 3.5-inch hard disk drive or a 2.5-inch solid-state drive into the secondary
optical drive bay in your computer.
This section provides instructions on how to install a tertiary 3.5-inch hard disk drive or a 2.5-inch solid-state
drive.
To install a tertiary 3.5-inch hard disk drive or a 2.5-inch solid-state drive, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See "Removing the computer cover" on page 32.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 33.
4. Remove the plastic panel in the front bezel for the drive bay you want to use. If there is a metal static
shield installed in the drive bay, remove the metal static shield.
5. Depending on whether you are installing a tertiary 3.5-inch hard disk drive or a 2.5-inch solid-state
drive, do one of the following:
• Install the hard disk drive into the 5.25-inch optical drive bracket. Then, fully tighten the four screws
to secure the hard disk drive to the 5.25-inch optical drive bracket.
Figure 49. Installing the tertiary hard disk drive
• Install the solid-state drive into the 5.25-inch optical drive bracket. To install the solid-state drive into
the 5.25-inch optical drive bracket, do the following:
60
ThinkStation E32 User Guide