Drain System - Maytag MHW9000YG0 Installation Instructions Manual

D IN SYSTEN
Drain system can be installed using a floor drain, wall standpipe,
floor standpipe, or laundry tub. Select method you need.
IMPORTANT." To avoid siphoning, only 4.5" (113 mm) of drain
hose should be inside standpipe. Always secure drain hose with
beaded tie strap.
Floor standpipe drain system
Minimum diameter for a standpipe drain: 2" (51 mm). Minimum
carry-away capacity: 17 gal. (64 L) per minute. A 1/4"(6 mm)
diameter to 1" (25 mm) diameter Standpipe Adapter Kit is
available (Part Number 3363920). Top of standpipe must be at least
30" (762 mm) high; install no higher than 96" (2.44 m) from bot-
tom of washer. If you have an overhead sewer and need to pump
higher than 96 inches, a sump pump and associated hardware are
needed. See "Alternative Parts".
Wall standpipe drain system
Laundry tub drain system
41_2 nn
[113_rnm)
Minimum capacity: 20 gal. (76 L). Top of laundry tub must
be at least 30" (762 mm) above floor; install no higher than
96" (2.44 m) from bottom of washer.
Floor drain system
Floor drain system requires a Siphon Break Kit (Part Number
285834), 2 Connector Kits (Part Number 285835), and an
Extension Drain Hose (Part Number 285863) that may be
purchased separately. See "Alternative Parts". Minimum siphon
break height: 28" (710 mm) from bottom of washer. (Additional
hoses may be needed.)
See requirements for floor standpipe drain system.
4