KitchenAid KERS507XSS02 Installation Instructions Manual page 3

Product Dimensions
A _
Cabinet Dimensions
Cabinet opening dimensions shown are for 25" (63.5 cm)
countertop depth, 24" (61.0 cm) base cabinet depth and
36" (91.4 cm) countertop height.
IMPORTANT: If installing a range hood or microwave hood
combination above the range, follow the range hood or microwave
hood combination installation instructions for dimensional
clearances above the cooktop surface.
A freestanding range may be installed next to combustible walls
with zero clearance.
A. 35_" +__" (90.8 cm +_ 0.3 cm)
cooktop height (minimum)
with leveling legs screwed all
the way in*
B. Model/serial/rating plates
(located behind the control
panel)**
C. 47_" +__" (119.7cm +_
0.3 cm) overall height
(minimum) with levering legs
screwed all the way in*
D. 28½" +_¼" (72.4 cm +_0.6 cm)
depth with handle
E. 26_" +__" (66.4 cm +_
0.3 cm)***
F. 2915_,, +_¼_,,(76. 0 cm +_
0.2 cm) width
*Range can be raised approximately 1" (2.5 cm) by adjusting the
leveling legs.
**Model/serial/rating plates may be rotated up from behind the
control panel for viewing from the front of the range.
***Excludes handle. Dimension given is from wall to front of oven
door and will vary based on electric outlet receptacle installation.
A. 18" (45. 7 cm) upper cabinet
to countertop
B. 13" (33.0 cm) upper cabinet
depth
C. 30" (76.2 cm) min. opening
width.
D. For minimum clearance to the
top of the cooktop, see
NOTE.
E. 30" (76.2 cm) min. opening
width
F. Cabinet door or hinge should
not extend into cutout*
G. 1V2" (3.8 cm) min. from right
side cabinet
H. 2" (5.1 cm) min. from floor
I. 7" (17.8 cm) min. from floor
J. 8" (20.3 cm) width
K. 3V2"(8.91 cm) min. from floor
Proper positioning of outlet shown above.
*Nothing located in shaded areas can extend more than
11/2"(3.8 cm) from wall or range will not slide all the way back.
NOTE: 24" (61.0 cm) minimum when bottom of wood or metal
cabinet is covered by not less than 1/4"(0.64 cm) flame retardant
millboard covered with not less than No. 28 MSG sheet steel,
0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or
0.020" (0.5 mm) copper.
30" (76.2 cm) minimum clearance between the top of the cooking
platform and the bottom of an unprotected wood or metal cabinet.