KitchenAid KDRP467KSS0 Installation Instructions Manual page 3

Parts
. o suppliedfor
lns aiia men
2 = #10 x 2" anti=tip
phillips head screws braskets
* Anti=tip bracket must be securely
attached to a wall stud. Thickness of
finished wail may require using
longer screws to anchor the bracket.
* L.P. conversion kit is included in
literature package.
, Backguard and istand trim. The
backguard included with the range
must be installed when a standard
24" (61 cm) deep base cabinet is
used and there is zero clearance
between the back edge of range
and combustible rear wall.
For island installations or other
installations with more than 5"
(12.7 cm) clearance to back wall,
use the optional stainless steel
island trim, included with the range,
to cover the backguard mounting
flanges.
Cabinet Opening
Dimensions
For minimum
clearance to top of
range, see Note.*
*Note: 42" (106.7 sin) rain. when bottom of weed or metal
cabinet is pretested by not less than 1/4" (6.64 sin)
flame reterdaet miltbcard severed with net less than No.
28 _SG sheet steel, 0,015" 0,4 mm) stainless steel,
0,024" e,6 mm aum hum or 0,020" 0,5 mm copper,
48" (121,!} sin) mirL clearance between the top of the
seeking platform and the bottom of an unprotected wood
or metal cabinet,
/
junction box to be
located in this area
30-114" (02.1
openieg width
sm)min.
dearaese from both sides
of range to side wall or
ether sombusOble
mateNal above sookieg
surface
0""(0 sin) sleararme frero
both sides and bask of
range to adjacent
sembustible sonstrustion
below seeking surface
gas line opening to be
. located in this area
_- .. 5=1/2""(14 sm)