KitchenAid KDRP467KSS0 Installation Instructions Manual page 6

Tip OverHazard
A chitd
or adult can tip the range
and be killed.
Connect anti-tip bracket to walt
behind range.
Reconnect the anti-tip bracket, if
the range is moved.
Failure to follow these instructions
can result in death or serious
burns to chitdren and adults.
line I
I
I
._j wall stud
I
I
I
_ mounting
screws
I
I
I
I
Position top of anti-tip bracket at
line marked in step 5 and mark holes.
Drill two 1/8" (3 mm) holes. Use screws
provided to fasten anti=tip bracket to wall.
NOTE: Anti=tip bracket must be mounted
securely to stud in wall behind the range.
Depending on thickness of the wall
covering, longer screws may be required.
m Make electrical connection.
if your house has aluminum wiring, see
"Electrical requirements" page 5.
Electrical Shock Hazard
Turn power supply off before
connecting wires.
Use 8 gauge solid copper wire.
Electrically ground range.
Failure to follow these instructions
can result in death, fire, or
electrical shock.
This range must be connected to a
grounded, metallic permanent wiring
system or a ground connector shoutd
be connected to the ground terminat
or wire lead on the range.
This range is manufactured with a frame-
connected, green or bare ground wire
factory-crimped to the neutral (white)
wire. Connect the range cable to the
junction box through the U=L= or CSA=
listed conduit connector. Complete
electrical connection according to local
codes and ordinances.
Am Where Iocat codes Do Not
permit connecting the frame-ground
conductor to the neutral (white)
junction box wire: (Also used for
Canadian installations}.
4owire cable from power supply
b.reordeen b ac. w ire,
w_ree _J \ U.L.- or CSA= listed
/ conduit connector
4-wire cable from range
Ungrounded neutra_
Figure 1
1. Disconnect power supply.
2. Connect the flexible, armored cable
from the range to the junction box
using a U=L- or CSA-iisted conduit
connector. Tighten screws on conduit
connector.
3. Connect the two black wires
together; and the two red wires
together using twist-on connectors.
(See Figure 1.)
4. Separate the factory-crimped bare
and white range cable wires.
5. Connect the two white wires together
using twist=on connector.
6. Connect the bare ground wire from
the range cable to the grounded wire
in the junction box or other grounded
connector using twist-on connector.
(See Figure 1.)
Do Not connect bare ground wire
to neutrat (white) wire in junction
box.
m Where local codes permit
connecting the frame-ground
conductor to the neutral (white)
junction box wire. (Not used for
Canadian installations):
3-wire cable from
junction power supply
box_ _ black
J--" w,r0s
white _
_ir_Au
wire_
white and bare
grounding oven cable
wires -- factory [t
cdmpe_
4-wire cable from/range
Grounded neutra_
Figure 2
1. Disconnect power supply.
2. Connect the flexible, armored cable
from the range to the junction box
using a U.L= or CSA=listed conduit
connector. Tighten screws on conduit
connector.
3. Connect the two black wires together;
the two red wires together; and the
factory-crimped bare and white
cooktop cable wires to the white
(neutral) wire in the junction box using
twist=on connectors. (See Figure 2.)
m Remove cardboard or hardboard
from under range.