Table of Contents
Advertisement
Available languages
Available languages
Quick Links
iNSTALLATiON
AND SERVICE MUST BE PERFORMED BY A QUALiFiED
iNSTALLER, iMPORTANT:
SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S
USE.
READ AND SAVE THESE iNSTRUCTiONS
FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do nat store or use gasollne or other flammable
vapors and liquids in the vicinity
of this or any other appliance.
Your new wall oven has been designed to fit a limited
variety
of cutout sizes to make
the jab of installlng easier. The first step of your installatlan should be to measure your
current cutout dimensions and compare them to the cutout dimensions chart below
far
your model. You may find lltfle or no cabinet work being necessary.
United
States
Canada
Do not remove spacers (if equipped)
on the side walls and/or
an the back of the
built-ln oven. These spacers center the oven in the space provided.
The oven must be centered to
prevent excess heat bulldup that may result in heat damage
or fire.
NOTES:
1.
Base
must
be
capable
of
supporting
150
pounds
(68
kg)
for
27"
models
and
200
pounds
(90
kg)
for 30" models.
2. Allow at least 21" (53.3cm) clearance in front of oven for door
1" (2.5cm)
depth
when
it is open.
Min.
3. Dimension G (cutout depth) is critical
._L
to the proper
installation
of the
built-
in oven.
If the oven
decorative
trim
does
not
butt
against
the cabinet,
or if
I
H
noise
is heard
on convection
models,
B
|
verify
dimension
G to assure
it is the
I
required
depth,
t
4. For
a cutout
height
greater
than
2713/|6"
(70.6cm) add
......._
31"*
i,
.
.
.---'"
one 2 (5cm) wide wood shim
Doc)r
Open
of appropriate
height to each
(see
note 2
side
of the opening
under
the
appliance
side rails.
Suggested distance from floor
is 31" (78.7cm).
Minimum required distance is 4 1/2" (11.4cm)
Figure 1
27" and 30" Single Wall Ovens (Double ovens see Figure 2)
2" (5 crn) Wide Wood
Spacer if Needed
27" (68.6cm)
27 (68.6)
29t/16 (73.8)
24s/8 (62.5)
241/2 (62.2)
30" (76.2cm)
30 (76.2)
29t/16 (73.8)
28t/4 (71.8)
241/2 (62.2)
CUTOUT
DIMENSIONS
AND CABINET
WIDTH
F
H
MODEL
G (rain.)
I
Min.
Max.
Min.
Max.
27" (68.6cm)
247/8 (63.2)
251/4 (64.1)
231/2 (59.7)
275/_
(69.4)
281/2 (72.4)
271/8 (68.9)
Min.
30" (76.2cm)
281/2 (72.4)
29 (73.7)
231/2 (59.7)
275/_
(69.4)
281/2 (72.4)
301/8 (76.5)
Min.
Aii dimensions
are
in inches
(cm).
Printed
in Canada
P/N 318206000
(1106) Rev. A
English - pages 1-8
Espa_ol
- p6ginas
9-16
Advertisement
Table of Contents
Related Manuals for Kenmore 79048173002
Summary of Contents for Kenmore 79048173002
- Page 1 iNSTALLATiON AND SERVICE MUST BE PERFORMED BY A QUALiFiED United States iNSTALLER, iMPORTANT: SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S USE. READ AND SAVE THESE iNSTRUCTiONS FOR FUTURE REFERENCE. FOR YOUR SAFETY: Do nat store or use gasollne or other flammable vapors and liquids in the vicinity of this or any other appliance.
- Page 2 Do not remove spacers (if equipped) on the side walls and/or an the back of the built-in oven. These spacers center the oven in the space provided. The oven must be centered prevent excess heat buildup that may result in heat damage or fire.
-
Page 3: Importantnotesto The Installer
importantNotesto the Installer 3. Electrical Requirements 1. Read aii instructions contained i nthese installation This appliance must be supplied with the proper instructions before installing t hewalloven. voltage and frequency, and connected to an individual, 2. Remove all packing matedal f romtheoven properly grounded branch... -
Page 4: Electrical Connection
(If your appliance is equipped with white neutral conductor.) This appliance is manufactured with a white neutral Electrical Shock Hazard power supply and a frame connected copper wire. * Electrical ground is required on this appliance. The frame is grounded by connection of grounding * Do not connect to the electrical... -
Page 5: Cabinet Installation
5. Cabinet Installation oven is used in a new branch circuit installation (1996 NEC), mobile home, recreatlonaJ vehicle, where local codes DO NOT permit grounding through the neutral (white) wire, the appliance frame MUST Do nat lift the oven the door handle. HOT be connected to the neutral wire of the 4-wire electrical... -
Page 6: Mounting Screws
Install Bottom Trim 6 Install the Anti-tip Mounting Screws The wall oven can tip when the door is Place the top of the bottom trim over the side trim tabs on each side of the oven below the oven door open. - Page 7 8. For typical under counter installation of an electric built-in oven see Figure below. Cabinet side filler panels Only certain cooktop models may be installed over certain necessary to isolate the unit from built=in electric oven models. Approved cooktops and built-in adjoining cabinets.
-
Page 8: You Call For Service
Right Side of Cabinet 120v/60Hz Flexible Appliance Grounded Flare Union Outlet ?s uro Cabinet sides or filler panel Manual Shutoff Valve (To be accessible for shut-off Wall Oven Cabinet valve operation) TYPICAL UNDER COUNTER INSTALLATION OF A SINGLE ELECTRIC BUILT-IN OVEN WITH A GAS COOKTOP ABOVE 9. - Page 9 LA iNSTALACI6N Y EL SERViCIO DEBEN SER EFECTUADOS Estades Unides UN INSTALADOR CALIFICADO. IMPORTANTE: GUARDE ESTAS NSTRUCCIONES PARA USO DEL INSPECTOR LOCAL DE ELECTRICIDAD. LEA Y GUARDE ESTAS INSTRUCCIONES PARA REFERENCIA FUTURA. PARA SU SEGURIDAD: No almanece nl utillce gasoJlna u otros vapores Canada JJquldos inflamabies...
- Page 10 No quite los seperedores de los mutes leteroles a/y de le porte posterior del homo empotrodo. Estos espocladores centren el homo en el especlo provlsta. El homo debe ester centrodo pore prevenlr cancentroci6n exceslvo de color que podr_o resultor en do_os per el color o un incendlo. 1"...
- Page 11 Notas importantes para el instalador 3. Requerimientos El_ctricos I. Lea todas las instrucciones contenidas en este manual Se debe proveer el voltaje la frecuencia apropiados antes de instaJar el horno. este electrodom6stico, y conectarse a un circuito individual 2.Saque todo el material usado embalaje correctamente...
- Page 12 (Si su electrodom_sfico est6 equlpado con un conductor neutro blanco.) Este electrodom_sfico est6 fabrlcado con un sumlnlstro Riesgo de choque el_ctrlco el_ctrlco neutro blanco y un alambre de cobre conectado * Una puesta a tierra se requiere en este aparato. al armaz6n.
- Page 13 5. Instalaci6n del Gabinete Si el horno se usa en una instalaci6n de circuito de ramal nuevo (1996 NEC), en una casa rodante, en un vehiculo para recreaci6n o sl los c6digos locales NO permiten la conexi6n a tierra a tray, s del cable neutral No levante el homo per la manija...
- Page 14 6. Instalaci6n de los tornillos de montado Z Instalaci6n de la Guarnici6n Inferior El home de pared puede incllnarse Colocar la parte superior de la guarnici6n inferior cuanda la puerta esta ablerta. Los saportes sabre las leng_etas laterales del horno_ debajo mentaje que vlenen con el homo de pared deben...
- Page 15 8. Para una instalaci6n fipica de un horno el_ctrico incorporado debajo del mostrador, v_ase la figura. $61o ciertos modelos de tapas de cocina se pueden instalar sobre ciertos modelos Los paneles de relleno laterales de hornos el_ctricos empotrados. Las tapas de cocina y los hornos empotrados gabinete son necesarios para aislar...
- Page 16 ÷ 4"(10 cm) 5" Max. 6 1/2" Min. (12.7 cm) (16.5 cm) Adaptor de gas Lado dere- Tomacorriente cho del ga- Conector flexible para puesto a tierra binete Adaptor de 120Voltios de gas /60Hz ReguJador de Lados del gabinete_V o panel Ilenador resi6n V61vuJa de cierre manual...