Installing The Water Dispenser Line - Samsung RF31FMED User Manual

How to adjust the level
1. Open the freezer drawer and remove the lower
basket.
2. Insert a flat-blade screwdriver (-) into the notch
on the left control lever, and turn it counter-
clockwise to level the refrigerator. (You turn the
lever clockwise to lower the refrigerator and
counterclockwise to raise it.)
flat-blade screwdriver (-) Control Lever flat-blade screwdriver (-)
Control Lever
Both control levers must be touching the
floor to avoid possible personal injury or
CAUTION
property damage because of tipping.
If the right side is lower, perform the same
procedure, but with the right control lever.
It is difficult to remove the cover leg
front from the refrigerator, so we do not
recommend making small adjustments
with the control lever. Instead, refer to the
next page for the best way to make minor
adjustments to the doors.
14_ setting up
DA68-02894A-09.indb 14 DA68-02894A-09.indb 14
MAKING MINOR
ADJUSTMENTS TO THE
DOORS
Remember, a leveled refrigerator is necessary
for getting the doors perfectly even. If you need
help, review the previous section on leveling the
refrigerator.
Fixed part Fixed part
The left door is fixed. To make minor door
adjustments, adjust only the right door.
1. Pull out the flex door ( 1 ) to reveal the lower
hinge ( 2 ).
2. Insert the supplied allen wrench (5/32") ( 3 )
into the shaft ( 4 ) of the lower hinge.
3. Adjust the height by turning the hex wrench
DOWN DOWN
( 3 ) clockwise ( ) or counter clockwise (
UP UP
).
When you turn the hex wrench counter-
clockwise ( ), the door will move up.
2
3
4
1
INSTALLING THE WATER
DISPENSER LINE
A water dispenser with a fi lter is one of the helpful
features on your new refrigerator. To help promote
better health, the water fi lter removes unwanted
particles from your water. However, it does not
sterilize or destroy microorganisms. You may need
to purchase a water purifying system to do that.
The water line also connects to the ice maker.
For the ice maker to operate properly, water
pressure of 20-125 psi (138 ~ 862Kpa) is required.
Adjustment Adjustment
part part
3
2013. 12. 3. 2013. 12. 3. 8:45 8:45