Checking The Water Dispenser Line; Installing The Water Dispenser Line - Samsung rs61681gdsr User Manual

CHECKING THE WATER
DISPENSER LINE
A water dispenser is just one of the helpful features
on your new Samsung refrigerator. To help promote
better health, the Samsung water fi lter removes
unwanted particles from your water.
However, it does not sterilize or destroy
microorganisms. You will need to purchase a water
purifying system to do that. In order for the icemaker
to operate properly, water pressure of 138 ~862 kPa
is required. Under normal conditions, a 170 cc paper
cup can be fi lled in 10 seconds. If the refrigerator
is installed in an area with low water pressure
(below 138 kPa), you can install a booster pump to
compensate for the low pressure. Make sure the
water storage tank inside the refrigerator is properly
fi lled. To do this, press the water dispenser lever until
the water runs from the water outlet.
Water Line installation Kits are included with
unit. You can fi nd it in freezer(or fridge) drawer.
The new hose-sets supplied with the
appliance are to be used and that old hose-
sets should not be reused.
Parts for water line Installation
1 Water line fixer Water line fixer 2 Pipe connector Pipe connector
and screws and screws
4 Clip Clip
Connecting to the water supply line
1. First, shut off the main water supply line.
2. Locate the nearest cold, drinking water line.
3. Follow the Water Line Installation Instructions in
the installation kit.
CAUTION
The water line must be connected to
the cold water pipe.
If it is connected to the hot water pipe,
it may cause the purifier to malfunction.
DA68-02924A-06.indb 17 DA68-02924A-06.indb 17
3 Water line Water line
5 Water Filter Water Filter
Close Main Close Main
Water pipe Water pipe
Close Main Close Main
Water pipe Water pipe
4. After connecting the water supply to the water
filter, turn your main water supply back on and
Dispense about 3 L to clear and prime the water
filter.
INSTALLING THE WATER
DISPENSER LINE
Connecting the water line to the
refrigerator
1. Remove the cap from water line on the unit and
insert compression nut to the water line on the
unit after disassembling from provided water line.
2. Connect both water line from the unit and water
line in the kit
3. Tighten the compression nut onto the
compression fitting. Be careful no gap between
two items.
4. Turn water on and check for any leakage.
Remove cap Remove cap
Loosen a Loosen a
Water Line from Water Line from
unit unit
Water Line from Water Line from
Kit Kit
No gap No gap
No gap No gap
setting up _17 setting up _17
2015. 6. 17. 2015. 6. 17. 2:48 2:48