Installing The Water Dispenser Line - Samsung rsh5utpn User Manual

CHECKING THE WATER
DISPENSER LINE (OPTIONAL)
A water dispenser is just one of the helpful features
on your new Samsung refrigerator. To help promote
better health, the Samsung water fi lter removes
unwanted particles from your water. However, it
does not sterilize or destroy microorganisms. You
will need to purchase a water purifying system to do
that. In order for the icemaker to operate properly,
water pressure of 138 ~862 kPa is required. Under
normal conditions, a 170 cc paper cup can be fi lled
in 10 seconds. If the refrigerator is installed in an area
with low water pressure (below 138 kPa), you can
install a booster pump to compensate for the low
pressure. Make sure the water storage tank inside
the refrigerator is properly fi lled. To do this, press the
water dispenser lever until the water runs from the
water outlet.
Water Line installation Kits are included. You can
fi nd it in one of the freezer drawers.
The new hose-sets supplied with the appliance
are to be used and that old hose-sets should not
be reused.
INSTALLING THE WATER
DISPENSER LINE
For Interior model
Parts for water line Installation
1
Water line fi xer and screws
3 Water line
Connecting to the water supply line
1. fi rst, shut off the main water supply line.
2. locate the nearest cold, drinking water line.
3. follow the Water line Installation Instructions in the
installation kit.
The water line must be connected
to the cold water pipe. If it is connected
to the hot water pipe, it may cause the
purifi er to malfunction.
DA99-02318N-15.indb 19 DA99-02318N-15.indb 19
Pipe connector
2
4
Water Filter
CAUTION
4. After connecting the water supply to the water
fi lter, turn your main water supply back on and
dispense about 1l to clear and prime the water
fi lter.
Close Main Close Main
Water pipe Water pipe
Close Main Close Main
Water pipe Water pipe
Connecting the water line to the
refrigerator
1. Remove the dust cap from the water line on the
rear of the unit and fi t a compression nut from the
install kit.
2. Remove the water pipe from the install kit and fi t a
compression nut to one end.
3. Join the two pipes together using the compression
joint from the install kit ensuring that the joint is
water tight.
4. Join the other end of the install pipe to the main
water supply and turn on the water to check for
leaks.
Remove Remove
Loosen a Loosen a
cap cap
Water Line Water Line
from unit from unit
Water Line Water Line
from Kit from Kit
Only connect the water line to a drinkable water
source.
If you have to repair or disassemble the water
line, cut off 6.5mm of the plastic tubing to
make sure you get a snug, leak-free connection.
Before being used, the leakage in these
places should be examined
CAUTION
NO GAP NO GAP
No gap No gap
_19
setting up
2016. 3. 24. 2016. 3. 24. 4:07 4:07