Checking The Water Dispenser Line; Installing The Water Dispenser Line - Samsung DA68-02535A User Manual

CHECKING THE WATER DISPENSER LINE

A water dispenser is one of the helpful features on your new Samsung Refrigerator. To help promote better
health, the Samsung water fi lter removes unwanted particles from your water. However, it does not sterilize
or destroy microorganisms. You may need to purchase a water purifying system to do that.
In order for the ice maker to operate properly, a water pressure of 138~862 kPa is required.
Under normal conditions, a 170 cc (5.75 oz.) paper cup can be fi lled in 10 seconds.
If the Refrigerator is installed in an area with low water pressure (below 138 kPa), you can install a
booster pump to compensate for the low pressure.
Make sure the water storage tank inside the Refrigerator is properly fi lled. To do this, press the water
dispenser lever until the water runs from the water outlet.
Water line installation kits are include with unit. You can fi nd it in freezer drawer.

INSTALLING THE WATER DISPENSER LINE

Parts for water line Installation
1 Water line fi xer
and screws
Connecting to the water supply line
1. First, shut off the main water supply line.
2. Locate the nearest cold, drinking water line.
3. Follow the Water line Installation Instructions in the installation kit.
Close Main Close Main
Water pipe Water pipe
4. After connecting the water supply to the water fi lter, turn your main water supply back on and dispense
about 3 L to clear and prime the water fi lter.
The water line must be connected to the cold water pipe. If it is connected to the hot water pipe, it may
cause the purifi er to malfunction.
CAUTION
DA68-02535A(0.0).indb 19 DA68-02535A(0.0).indb 19
2 Pipe connector 3 Water line
Close Main Close Main NO GAP NO GAP
Water pipe Water pipe
setting up _19
2012.10.11 11:48:2 AM 2012.10.11 11:48:2 AM