Using The Magnify Feature - Hitachi CP-AW2519N Manual

Using the magnify feature

Press the MAGNIFY ON button on the remote control.
1.
The picture will be magnified, and the MAGNIFY dialog will
appear on the screen. When the MAGNIFY ON button is
pressed for the first time after the projector is turned on, the
picture will be zoomed by 1.5 times. On the dialog, triangle
marks to show each direction will be displayed.
The display magnification of the projector switches in order
2.
with every press of the MAGNIFY ON button.
For computer signals, HDMI
LAN or USB TYPE B port
1.5 times
For video signals, s-video signals, component video signals or HDMI
(Component) signals
1.5 times
While the triangles are displayed on the dialog, use the ▲/▼/◄/► cursor
3.
buttons to shift the magnifying area.
Press the MAGNIFY OFF button on the remote control to exit magnification.
4.
● The MAGNIFY dialog will automatically disappear in several seconds with no
operation. The dialog will appear again if the MAGNIFY ON button is pressed
when the dialog has automatically disappeared.
● The magnification is automatically disabled when the displaying signal or its
display condition is changed.
● While the magnification is active, the keystone distortion condition may vary.
It will be restored when the magnification is disabled.
● Some horizontal stripes might be visible on the image while magnification is
active.
● This function is not available in the following cases:
- A sync signal in the range not supported is input.
- There is no input signal.
28
TM
2 times 3 times
2 times 1 time
(RGB) signals, input signals from the
4 times 1 time
Operating
MAGNIFY
ON/OFF button
MY SOURCE/
VIDEO COMPUTER DOC.CAMERA
ASPECT AUTO SEARCH BLANK
MAGNIFY PAGE VOLUME
FREEZE
UP
ON
DOWN
OFF
MY BUTTON
KEYSTONE MUTE
TM