Power On/Off - Hitachi CP-AW2519N Manual

Power on/off

Turning on the power
Make sure that the power cord is firmly
1.
and correctly connected to the projector
and the outlet.
Make sure that the POWER indicator is
2.
steady orange (
Confirm that there is nothing that the lens
3.
door hits while opening. Press STANDBY/
ON button on the projector or the
remote control. The lens door opens, the
projection lamp lights up, and the POWER
indicator begins to blink green. When the
power is completely on, the indicator will
stop blinking and light in steady green
111).
(
WARNING ►Never look into the projection lens or mirror while
the projection lamp lights, since the projection lamp ray may cause
a trouble on your eyes.
►Be careful not to pinch your finger with the lens door, to prevent
an injury.
►Do not place the projector vertically with the lens door open
as shown in the figure on the right. It could cause malfunction or
injury. Tabletop use must be set up with the designated optional
accessories.
►Do not stand under the projector mounted on the wall or ceiling,
when its lens door is opening or closing. Moreover, do not look at
the mirror when the lens door is opening or closing.
►Never touch a lens door or mirror. If the mirror is broken, the
projected image will be distorted. Close the lens door, and contact
your dealer.
20
111).
Power on/off
STANDBY/ON button
POWER indicator
MY SOURCE/
VIDEO COMPUTER DOC.CAMERA
ASPECT AUTO SEARCH BLANK
MAGNIFY PAGE VOLUME
FREEZE
ON UP
OFF DOWN
MY BUTTON
KEYSTONE MUTE
FOCUS D-ZOOM
POSITION MENU
ENTER
ESC RESET