Billy Goat QV550 Owner's Manual page 6

QV PUSH Operator's Manual
OPERATION
VACUUMING OPERATION
VACUUM NOZZLE HEIGHT ADJUSTMENT: Is adjusted by turning the knob clockwise increases height and counter-clockwise to
lower it. Adjust nozzle height according to surface conditions and debris size; For vacuuming on flat surfaces, set nozzle 1/2" (12.7
mm) to 5/8" (15.8 mm) above ground; Higher for uneven terrain and turf.
FOR MAXIMUM PICKUP: Adjust nozzle close to debris, but without blocking airflow into the nozzle.
NOTE: Never bury nozzle into debris.
:
CLEARING A CLOGGED NOZZLE & EXHAUST Turn engine off and wait for impeller to stop completely and
disconnect spark plug wire. Wearing durable gloves, remove clog, this may require removing the front nozzle. Danger, the clog
may contain sharp materials. Reconnect spark plug wire.
DEBRIS BAG
.
Debris bags are normal replaceable wear items
Note: Frequently empty debris to prevent bag overloading with more weight than you can lift.
Use the dust skirt when debris will be vacuumed in dusty conditions.
DO NOT place bag on or near hot surface, such as engine. Run engine at 1/2 throttle for first 1/2 hour to condition new bag. Your
new bag requires a break-in period to condition the pores of the material against premature blockage. The entire bag surface serves
as a filter, and must be able to breathe to have good vacuum performance. Be sure engine has come to a complete stop before
removing or emptying bag.
HOOD FILTER
Hood filters are normal replaceable wear items.
The hood filter is for use in dry dusty conditions only. DO NOT get the filter wet. Clean with light compressed air only.
DUST SOCK
Dust Skirts are normal replaceable wear items.
See next page for Dust sock care.
This vacuum is designed for picking up trash, organic material and other similar debris.
However, many vacuums are used where dust is mixed with trash. Your unit can intermittently vacuum in dusty areas. Dust is the
greatest cause of lost vacuum performance. However, following these rules will help maintain your machine's ability to vacuum in
dusty conditions:
•Run machine at idle to quarter throttle.
•The debris bag must be cleaned more frequently. A vacuum with a clean, pillow soft bag will have good pickup performance. One
with a dirty, tight bag will have poor pickup performance. If dirty, empty debris and vigorously shake bag free of dust.
Having one or more spare debris bags is a good way to reduce down time while dirty bags are being cleaned.
•DO NOT leave debris in bag while in storage.
Part No 831504 Form No F120512B
6