IN THE INTEREST OF SAFETY BEFORE STARTING ENGINE, READ AND UNDERSTAND THE “ENTIRE OPERATOR'S MANUAL & EN- GINE MANUAL.” THIS SYMBOL MEANS WARNING OR CAUTION. DEATH, PERSONAL INJURY AND/OR PROPERTY DAMAGE MAY OCCUR UNLESS INSTRUCTIONS ARE FOLLOWED CAREFULLY. The engine exhaust from this product contains chemicals known to the WARNING! State of California to cause cancer, birth defects or other reproductive harm.
Your Billy Goat is shipped from the factory in one carton and is 9. ATTACH preassembled hose boom on top of housing using a hitch pin completely assembled except for the exhaust elbow, nozzle, handle (item 10).
(Billy Goat Part no. 790112) available from your 6) Tighten down the clamp with 2, 1 3/4" carriage bolts, 2 Billy Goat dealer. The unit can be mounted to allow vacuuming knobs, and 2 lock nuts (removed hardware in step 1).
Page 6
OPERATION continued STARTING INTAKE OPERATION: With machine running and fully assembled, move the nozzle in sweeping motions over debris. Always allow air to flow into the nozzle along with the debris. PUT OIL IN ENGINE BEFORE STARTING. Do not completely block the nozzle when vacuuming, it will reduce performance, and increase clogging (See figure 3).
Page 7
OPERATION continued HANDLING & TRANSPORTING ADJUSTING HOSE BOOM: Properly adjusting the boom will prevent most hose clogs from The unit is equipped with small front wheels to allow for easier occurring and will maximize vacuum performance by keeping transportation to storage. With unit removed from its mounting, the hose straight and perpendicular to the housing (see fig.
OPERATOR'S INSTRUCTIONS. Note: 3/4"-10 x 3" bolt is included in each impeller replacement kit or the bolt can be ordered from your local Billy Goat Dealer (part no. 790214). RECONNECT ALL GUARDS AND HOSE BEFORE STARTING ENGINE.
Page 9
MAINTENANCE continued Follow these hourly INTERLOCK SYSTEM Maintenance Schedule maintenance intervals. Every Every 5 hrs Every 10 Every 25 With hose coupler installed (as shown in Fig. 4) the switch is Maintenance Operation or (Daily) open & engine is not grounded out, allowing engine to run. Engine (See Engine Manual) Inspect battery for damage or leak Check battery terminal for corrosion...
Engine Service and Warranty WARRANTY PROCEDURE Contact your nearest engine manufacturer's authorized Please fill in the WARRANTY CARD and send the upper part to Billy Goat. servicing dealer. The WARRANTY terms are stated on the lower part which remains with the user.