Side Trim
3/8"
(93
mm)
'J'°" 1 !
(1.5 ram)
1/8"
(3,2 ram)
__
3/16"
--_
_
(4,5 mm)
2. If the panel is more than %" (9.5 mm) thick, route the front
edge to allow the side panel to fit into the trim.
U
Recessed
Inset Installation
Dimensions
1. Measure the distance from point A (as shown) to back wall.
2. Route the front edge of the support board or attach a %"
(9.5 mm) board to hold the panel in the cabinet side trim.
Inset Installation
Dimensions
1. Measure the distance from point A (as shown) to the back
wall. Add r/32"(0.8 mm) to this measurement to allow the side
panel to fit into the trim.
INSTALLATION
REQUIREMENTS
......
.
IMPORTANT:
•
Installer: Leave Installation Instructions with the homeowner.
•
Homeowner:
Keep Installation Instructions for future
reference. Save these Installation Instructions for the local
electrical inspector's use.
Tools needed:
Gather the required tools and parts before starting installation.
Read and follow the instructions
provided with any tools listed
here.
•
Hand drill or electric drill
•
T27 Torx ®t screwdriver
(properly grounded)
•
rr/32"nut driver
•
Drill bits
•
%" and rA" open-end
•
Adjustable wrenches (2)
wrenches
•
Phillips screwdriver
•
%2" Allen wrench
•
Small level
•
%6" socket wrench
Parts needed:
•
#8 x 3" (7.6 cm) or longer wood screws (6)
•
2" X4"
X
32" (5 cm x 10 cm x 81 cm) wood board (1 or 2)
•
Make custom or overlay panels or consult a qualified
cabinetmaker
or carpenter to make the panels. See "Design
Specifications."
•
If you are connecting the water line directly to copper tubing
and not to a shutoff valve, you need a ferrule, a union, and a
1/4"(6.35 mm) compression
fitting.
•
Appliance dolly
•
Tape measure
1-®TORX is a registered trademark
of Textron Innovations
Inc.
12