Thermador KBUIT4255E Installation Instructions Manual page 14

g_,_ i_ = _ , _ _" ®
Custom side panels may be needed when not enough space is
available to have cabinets on both sides of the refrigerator or
when the refrigerator is placed at the end of a cabinet run. You
may choose an Inset or Recessed Inset panel installation.
Refrigerator and Side Trim Dimensions
The width and height of a side panel are determined by the type of
installation you are planning.
NOTES:
• The dimensions shown are actual product dimensions and
may not reflect the needed installation dimensions.
• The side panel should be a minimum of 1/2"(1.27 cm) thick
to avoid warping.
• If the opening depth is 25" (63.5 cm) or more, you may
want to install a support board on rear wall.
Refrigerator
Side Trim
Overlay
t
23%"
(59.40 cm)
3/8"
(9.7 mm)
1_611
(1.5 mm)
(4.5 mm)
w,_)L
(3.2 mm)
Inset Installation Dimensions
1. Measure the distance from point A (as shown) to the back
wall. Add 1/32"(0.8 mm) to this measurement to allow the side
panel to fit into the trim.
2. If the panel is more than 3/8"(9.5 mm) thick, rout the front edge
to allow the side panel to fit into the trim.
1-
Recessed Inset Installation Dimensions
1. Measure the distance from point A (as shown) to back wall.
2. Rout the front edge of the support board or attach a 3/8"
(9.5 mm) board to hold the panel in the cabinet side trim.
INSTALLATION
REQUIREMENTS
ls
IMPORTANT:
• Installer: Leave Installation Instructions with the homeowner.
• Homeowner: Keep Installation Instructions for future
reference. Save these Installation Instructions for the local
electrical inspector's use.
TOOLS NEEDED:
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
• Cordless drill
• Drill bits
• Adjustable wrenches (2)
• Phillips screwdriver
• Small level
• Appliance dolly
PARTS NEEDED:
• T27 Torx ®tscrewdriver
• 1V32" n ut driver
• 3/8"and 1/2"open-end wrenches
• 8/32" A llen wrench
• 8/ld' socket wrench
• Tape measure
#8 x 3" (7.6 cm) or longer wood screws (6)
2" x 4" x 32" (5 cm x 10 cm x 81 cm) wood board (1 or 2)
Make custom or overlay panels or consult a qualified
cabinetmaker or carpenter to make the panels. See "Design
Specifications."
If you are connecting the water line directly to copper tubing
and not to a shutoff valve, you need a ferrule, a union, and a
1/4"(6.35 mm) compression fitting.
1-®TORX is a registered trademark of Textron Innovations Inc.
14