Top Grille Panel - Routing Requirements
Top and bottom edges of the top panel should be edge routed
1/2"(1.3 cm) and 3/8"(9.5 mm), respectively. Both ends should be
edge routed 7/8"(2.2 cm) as shown.
(6.35 mm)
max.
(2.2 cm)
Ji1/4 ''
Top
(6.3x5
" mm)
(2.2 cm)
NOTE: When creating a panel with face detail, the offsets will be
hidden and must be accounted for in order to center the detail in
the top grille.
1/2"
1
Top
(1.3 cm)
rnin.
Center face
detail between _
offsets
1/4"
(6.35 mm) max.
3J811
(9.5 mm)
min.
m
Bottom
_._
1/4"
(6.35 mm) max.
Door Panels - Routing Requirements
If an extended handle kit is used, then routing the handle side of
the panels is not required. See "Handle and Door Clearances" for
more information on ordering extended handles.
If the standard handle is used, rout the entire handle side of both
panels 31/4 '' (8.25 cm) to allow for finger clearance. Then rout the
other sides 1" (2.54 cm).
Standard Handle - Top View
"T-
31,/4 ''
(8.25 cm)
_1
+1
mln.
Hinge Side
Door
Door
I
__
Panel
Panel
2" (5 cm)
1"
min.
(2.54 cm)
Door Panel - Side View
Q_
Y
11