Washing Sequence - Haier HWM60-113S User Manual

Washing sequence

Wash selector
(standard current,
strong current)
Wash timer
(To set to below 2 minute,
first set to 5 minute then
turn it back. it can increase
the service life of the timer).
15
3
6
12
9
WASH SELECTOR
WASH TIMER
Wash
1. Fill the water and add the dissolved washing
powder to make the water level reach the preset
position. (Figure 1)
Run washing program for some time to stir and
dissolve the powder completely.
2.Put in the laundries. If the water quantity is
insufficient, please add water.
3.Select the current.
Select the strength of the current according to
the laundries. (Figure 2
4.Select the washing time
Select the washing time according to the
laundries. (Figure 3)
5.After washing, the buzzer will ring. Set the "WASH
SELECTOR" at "DRAIN". (Figure4).
8
Spin timer
Spin water-filling entrance
(to set to below 1 minute,
first set to 2 minute then
turn it back. it can increase
the service life of the timer).
WASH SELECTOR
15
12
WASH TIMER
WASH SELECTOR
Midway spinning
1. Put the laundries into the spin tub evenly and smoothly.
2. Spin
(1) Put the gland in properly.
Please put in the gland properly even if the laundries quantity is small.
SPIN TIMER
(2) Close the inner and outer cover of the spin tub.
Figure 1
(3) Spin for 1-2 minutes.
Figure 2
3. Run the foam-removing spinning.
3
(1) Open the outer cover of the spin tub.
6
9
(2) Insert the water inlet hose into the spin
water-filling entrance on the control panel.
Figure 3
Fill water for about 1 minute.
(3) Close the outer cover of the spin tub.
Spin for 1-2 minutes.
Figure 4
Push Gland
Push
The laundries
Proper Proper
No gland
are slanting
Outer cover of
the spin tub
Inner cover of
the spin tub
Water inlet hose
Spin water-filling
entrance
9