Table of Contents
Advertisement
H.1. setting ringer Volume & ringer type
Different ringer volumes and ringer types can be programmed to each handset.
Handset Ringer Volume
Key Map:
Audio setting
ringer Volume
1. To arrive at this menu, push
browsing until "Audio Setting" is shown on the screen. Press
. Press
/
to select "Ringer Volume" and press
3. Press
/
to select the volume you want. (you will hear a sample of each
as you scroll through), then press
4. Press
to exit and return to standby. If you select Volume "Off",
displayed.
Handset Ringer Type
Key Map:
Audio setting
ringer type
select the ringer type
1. To arrive at this menu, push
browsing until "Audio Setting" is shown on the screen. Press
. Press
/
to select "Ringer Type" and press
3. Press
/
to select the "External", "Internal", "Paging", "Alarm", or
"Appointment" and press
4. Press
/
to select the melody you want. (you will hear a sample of each
as you scroll through), then press
5. Press
to exit and return to standby.
i.
ADVAnceD operAtion
Special Attention!!
the following sections are only for users who are familiar with electronics products.
failure in following steps correctly may stop your Dect phone from normal operation.
select the volume
in standby mode, and use
to confirm.
select the option
in standby mode, and use
to confirm.
to confirm your selection.
i.1.
to register a new handset
When you register a new handset to your base, you will be asked to enter your base
PIN code. To enable registration mode on the base unit, press and hold the PAGE
button for five seconds. Before registration, make sure the new handset is fully
charged and that you have the base and the handset in front of you. Also, make sure
that all handsets and the base are in standby.
On the handset you want to register:
/
to start
Key Map:
Add. settings
1. Press
will be
. Press
3. Press
4. Press
If the base already has the maximum number of 6 handsets registered, you will need
to deregister one of the existing handsets before you can register the new handset.
See section i.2. Deregister a handset or a base.
/
to start
On the handset:
Enter the base PIN code.
Pre-set base PIN code is 0000.
When in standby, the new handset number will be displayed.
The handset will automatically be allocated with the next available handset number.
If the registration is unsuccessful, the display will show "searching" and you will need
to follow the registration procedure again.
i.2.
Deregister a handset or a base
If you have more than one handset registered to your base or more than one base
registered to your handset(s), you can deregister both the handset from the base or
the base from the handset. Before deregistration, make sure that all handsets and the
base are in standby.
register
to access the main menu.
/
to select "Add. Settings" and press
/
to display "Register" and press
/
to select your base number and press
select the base number
to confirm.
to confirm.
15
Hide quick links:
Advertisement
Table of Contents
