Normal Operation - Jacob Jensen 80 User Manual

4. Press / to select the option (i.e. "Warning", "Call waiting", "Range
Alarm") and to confirm.
5. Press / to display either "On" or "Off" and press
"Key", select from "pattern 1-3" or "Off" and press
6. Press to exit and return to standby mode.
D.12. DiAl mode
You can set your phone to use either "Tone" or "Pulse" dialing. The pre-set setting is
"Tone" dialing, where you will hear a tone beep each time you dial a number. Most
modern exchanges and switchboards use "Tone" dialing, so you should not need to
change this setting. Only change it if your switchboard uses "Pulse" dialing or if you
cannot make a call using "Tone" dialing.
Key Map:
setting Base Additional
tone/pulse
1. Press to access the main menu.
. Press / to select "Setting Base". Press
3. Press / to select "Additional". Press
4. Press / to select "Dial Mode".Press
displayed.
5. Press / to select either "Tone" or "Pulse". Press
6. Press to exit and return to standby mode.
D.13. tone dialing switch-over
If you have set your phone to use "Pulse" dialing, you can switch temporarily to
"Tone" dialing for the duration of a call:
1. Press
. Enter the number you want. Press and hold
entered after the "D" will be dialed using tone dialing.
D.14. prefix dialing
If you need to add a prefix to the number for a long distance call, or if you need to
add your saved area code to the number, do the following:
to confirm. For
Dial mode select
. The current setting is
to confirm.
"D" will be displayed. Any digits
Key Map:
setting Base Additional
the number
1. Press to access the main menu.
. Press / to select "Setting Base". Press
3. Press / to select "Additional". Press
4. Press / to select "Prefix Dial".Press
displayed.
5. Enter the number using the number keypad or press
Press to confirm.
6. Press to exit and return to standby mode.
D.15. call barring
When switched on, Call Barring prevents calls from being made to a specific number,
area code or international code.
Key Map:
setting Base call Barring
select on/off
1. Press to access the main menu.
. Press / to select "Setting Base". Press
3. Press / to select "Call Barring". Press
4. Enter the number using the number keypad or
confirm.
5. Press / to select "On" or "Off". Press
6. Press to exit and return to standby mode.
e.

normAl operAtion

e.1. to make a new call
1. You can only make a call with your handset. You cannot make a call from your base
unit.
. On the handset, enter the telephone number to be called and press
press again, you can toggle to speaker phone). The entered number will be
dialed automatically. After a short delay, the call timer will start timing the call, if
"Time" is selected in "Talk Display" menu.
prefix Dial enter
. The current setting is
to clear.
enter the number
to clear. Press to
to confirm.
(if you
11