Whirlpool GS440LEMT2 Installation Instructions And Operation Manual page 9

1, Move range c lose tocabinet opening.
2, Remove cardboard orhardboard from under range. CarefuJly
move range i ntofinal p osition.
3, Pull d rawer open tofirst s topposition. Liftfront o fdrawer to
clear d rawer guides. Remove drawer and setitaside ona
protected surface. See Use and Care Guide f oryour m odel
drawer removal.
4,
Making sure the anti-tip bracket is installed:
[] Look for the anti-tip bracket securely attached to floor.
[] Slide range back so rear range foot is under anti-tip bracket.
5,
if installing the range in a mobile home, you must secure the
range to the floor. Any method of securing the range is
adequate as long as it conforms to the standards in the
"Location Requirements" section.
Place rack in oven. Place level on rack, first side to side; then
front to back.
If range is not level, pull range forward until rear leveling leg is
removed from the anti-tip bracket. Use %" drive ratchet and
channel lock pliers to adjust leveling legs up or down until range
is level. Push range back into position. Check that rear leveling
leg is engaged in anti-tip bracket.
NOTE: Oven must be level for satisfactory baking performance.
Typical rigid pipe connection
A combination of pipe fittings must be used to connect the range
to the existing gas line. Your connections may be different,
according to the supply line type, size and location.
1, Apply pipe-joint compound made for use with LP gas to all
pipe thread connections.
2, Using a pipe wrench to tighten, connect the gas supply to the
range.
/
A
F
!
i i'
G
A. Gas pressure regulator F{ Manual gas shutoff valve
B. 90 ° elbow G. ½" or ¾" gas pipe
C. Nipple H. Nipple
D. Union L Union
E. Black iron pipe J. 90 ° elbow
Typical flexible connection
1, Apply pipe-joint compound made for use with LP gas to the
smaller thread ends of the flexible connector adapters (see B
and G in following illustration).
2. Attach one adapter to the gas pressure regulator and the
other adapter to the gas shutoff valve. Tighten both adapters.
3, Use a 1_16" combination wrench and channel lock pliers to
attach the flexible connector to the adapters. Check that
connector is not kinked.
A B C
i
D
S
H G F
A. Gas pressure regulator
B. Use pipe-joint compound
C. Adapter (must have ½" male
pipe thread)
D. Flexible connector
E. Manual gas shutoff valve
F. ½" or ¾" gas pipe
G. Use pipe-joint compound
H, Adapter