Whirlpool GS440LEMT2 Installation Instructions And Operation Manual page 14

To Convert Standard Surface Burners
1. Remove burner cap.
2. Using a T20 Torx screwdriver, remove the burner base.
NOTE: Reinstall one of the screws through the range
cooktop to hold orifice spud holder in place while removing
and replacing orifice spuds.
3. Apply masking tape to the end of a 7 mm nut driver to help
hold the gas orifice spud in the nut driver while changing it.
Press nut driver down onto the gas orifice spud and remove
by turning it counterclockwise and lifting out, set gas orifice
spud aside.
A
....... _ D
4,
A. Orifice spud
B. Orifice spud holder
C. Screw
D. Spank electrode
Gas orifice spuds are stamped with a number, marked with
1 color dot, and have a groove in the hex area. Replace the
Natural gas orifice spud with the correct LP gas orifice spud.
_ A
A. G_OOVO
Refer to the following chart for correct LP gas orifice spud
placement.
LP Gas Orifice Spud Chart for Standard Surface Burners
Burner Rating Color Size ID Number
12,000 BTU Green/Magenta 1.03 mm L103
11,000 BTU Green/Yellow 0.99 mm L99
8,000 BTU Green/Lt. Blue 0.80 mm L80
5,000 BTU Green Brown 0.65 mm L65
NOTE: Refer to the Model Number and Serial Plate located
behind the left side of the storage or warming drawer for proper
sizing of spuds for each burner location.
5. Place Natural gas orifice spuds in plastic parts bag for future
use and keep with literature package.
6. Replace the burner base using both screws.
7. Replace burner cap.
8. Repeat steps 1-7 for the remaining burners.
14
To Convert Oven Bake Burner
1. Remove oven racks.
2. Use a 1/2"combination wrench to turn the orifice hood down
snug onto pin (about 2 to 21/2turns).
IMPORTANT: Do not overtighten.
The oven bake burner flame cannot be properly adjusted if
this conversion is not made. See "Adiust Oven Bake Burner
Flame" section.
A. Orifice hood
B. Pin
C. Natural gas: increase gas - increase flame size
(preset at factou for Natural gas)
D. LP gas." decrease gas - decrease flame size
To Convert Oven Broil Burner
Use a 1/2"combination wrench to turn the orifice hood down snug
onto the pin (about 2 to 21/2turns).
IMPORTANT: Do not overtighten.
The oven broil burner flame cannot be properly adiusted if this
conversion is not made. See "Adjust Oven Broil Burner Flame"
section.
A. Orifice hood
Replace oven racks in oven cavity. Insert storage drawer or
warming drawer into slide rails on sides of drawer opening. Lift
front of drawer slightly and push firmly to close drawer.
1,
2.
Refer to the "Make Gas Connection" section on page 9 for
properly connecting the range to the gas supply.
Refer to the "Electronic Ignition System" section on page 10
for proper burner ignition, operation, and burner flame
adjustments.