Table of Contents
Advertisement
Flat tire
234
Make sure that the ground on which the
vehicle is standing and where you place the
jack is solid, level and not slippery. If
necessary, use a large underlay. On slippery
surfaces, such as tiled floors, you should use
a non-slip underlay, for example a rubber mat.
Do not use wooden blocks or similar objects
as a jack underlay. Otherwise, the jack may
not be able to achieve its load-bearing
capacity if it is not at its full height.
Never start the engine when the vehicle is
raised.
Also observe the notes on the jack.
Using lug wrench :, loosen the bolts on
X
the wheel you wish to change by about one
full turn. Do not unscrew the wheel bolts
completely.
The mounting for the jack is centered
between the front and rear wheel housings
(arrow).
G
WARNING
The jack is designed exclusively for jacking up
the vehicle at the jacking points. The jack
saddle must be placed centrally under the
jacking point.
If you do not position the jack correctly in the
jacking point, the vehicle can fall off the jack
and seriously or fatally injure you or others.
! The jack is designed exclusively for
jacking up the vehicle at the jacking points.
Otherwise, your vehicle could be damaged.
Position jack = at jacking point ;.
X
Make sure that the base of the jack is
X
positioned directly under jacking point ;.
Turn crank ? clockwise until jack = sits
X
completely on jacking point ; and the
base of the jack lies evenly on the ground.
Turn crank ? until the tire is raised a
X
maximum of 1.2 inches (3 cm) off the
ground.
Advertisement
Chapters
Table of Contents
