Table of Contents
Advertisement
vehicle enters the blind spot monitoring
range from behind or from the side. When you
overtake a vehicle, the warning only occurs if
the difference in speed is less than
7 mph(12 km/h).
The yellow indicator lamp goes out if reverse
gear is engaged. In this event, Blind Spot
Assist is no longer active.
The brightness of the indicator/warning
lamps is adjusted automatically according to
the ambient light.
Collision warning
If a vehicle is detected in the monitoring range
of Blind Spot Assist and you switch on the
corresponding turn signal, a double warning
tone sounds. Red warning lamp : flashes. If
the turn signal remains on, vehicles detected
are indicated by the flashing of red warning
lamp :. There are no further warning tones.
Switching on Blind Spot Assist
Make sure that Blind Spot Assist
X
(
page 153) is activated in the on-board
Y
computer.
Ensure that key position 2 has been
X
selected with the Start/Stop button.
Warning lamps : in the exterior mirrors
light up red for approximately
1.5 seconds and then turn yellow.
Driving systems
Z
143
Advertisement
Chapters
Table of Contents
