Mercedes-Benz Coupe Operator's Manual page 211

Do not run the engine while programming the
integrated remote control. Inhalation of
exhaust gas is hazardous to your health. All
exhaust gas contains carbon monoxide (CO),
and inhaling it can cause unconsciousness
and possible death. All exhaust gas contains
carbon monoxide (CO), and inhaling it can
cause unconsciousness and possible death.
i
Notes about the declaration of conformity
can be found here (
Programming the integrated garage
door opener on the rear-view mirror
Programming buttons
G
WARNING
Only press the button on the integrated
garage door opener if there are no persons or
objects present within the sweep of the
garage door. Persons could otherwise be
injured as the door moves.
Integrated garage door opener in the rear-view
mirror
Garage door remote control A is not part of
the integrated garage door opener.
The first time before programming, clear
X
the integrated garage door opener memory
( page 211).
Y
Select key position 2 with the Start/Stop
X
button.
page 21).
Y
Press and hold one of buttons ; to ? on
X
the integrated garage door opener.
After a short time, indicator lamp : starts
flashing yellow.
i
Indicator lamp : lights up yellow as soon
as button ;, = or ? is programmed for
the first time. If the selected button has
already been programmed, indicator
lamp : will only light up yellow after ten
seconds have elapsed.
Release button ;, = or ?.
X
Indicator lamp : flashes yellow.
Point garage door remote control A
X
towards buttons ; to ? on the rear-view
mirror at a distance of 2 to 8 inches (5 to
20 cm).
i
The required distance between remote
control A and the integrated garage door
opener depends on the garage door drive
system. Several attempts might be
necessary. You should test every position
for at least 25 seconds before trying
another position.
Press and hold button B on remote control
X
A until indicator lamp : lights up green.
If indicator lamp : lights up green or
flashes, then programming has been
successful.
Release button B on remote control A for
X
the garage door drive system.
If indicator lamp : lights up red: repeat
X
the programming procedure for the
corresponding button on the rear-view
mirror. When doing so, vary the distance
between remote control A and the rear-
view mirror.
i
If the indicator lamp flashes green after
successful programming, the garage door
system is using a rolling code. After
programming, you must synchronize the
garage door opener integrated in the rear-
view mirror with the receiver of the garage
door system.
Features
209
Z